We will begin by building the stand. Messed up already. 🙂 I always think about designing a more detailed stand… … but it usually just ends up being simple and black. Cover up those unsightly studs! 🙂 Building the support column. The Technic liftarm does a great job of reinforcing the column, so that it doesn’t fall apart when being used. This axle anchors the liftarm to the bricks in the stand, which gives it a very solid anchor. Time to build the horse’s body. I really like the new inverted curved slopes. The sides of the horse. Let’s build two of these! The head. And the neck. Always brush the mane of your horse. Lower neck. The tail. Side details. Time to put the body together. This arm controls the rocking of the body while the horse runs. It’s starting to look like a horse! Time to build a drive shaft. The bent arms are a way to make an arm that is 4.5 studs long. Now let’s build some legs. We’ll need four of them. The rear right leg controls all of the other motion, Lower legs. They each need a control rod to connect to the drive shaft. Now we need to add a crank to control it. Run, horsey, run! We should really add a motor. Finished. Thanks for watching/listening!