Zebra 105SLPlus: Ribbon & Media Loading

, , Leave a comment


105SL Plus Ribbon and Media loading. Open the media door. Pull out the Media Supply Guide. Place the roll of media on the supply hanger and push it back. Slide in the Media Supply Guide until it touches the edge of the role. Loosen the thumb screw under the outer
media guide and slide the guide to its furthest outboard position. Open the Printhead. Thread the media under the Media Dancers Assembly Roller, the Media Guide Roller, and the Upper Media Sensor. Push the media forward until it passes
under the Printhead Assembly, under the Snap Plate, and over the Platen Roller. Slide the outer media guide in until it touches the edge of the media. Tighten the thumb screw under the Outer Media Guide. Place the ribbon on the Ribbon Spindle and push it back. A Ribbon Leader will make ribbon loading easier. Tear off a strip of media about 6 inches or 15 centimeters. Peel a label from the backing Use this label to attach the end of the
ribbon to the Media Strip and make a Ribbon Leader. Thread the ribbon over the media Dancer and under the Ribbon Guide Roller. Push the Ribbon Leader forward until it passes under the Printhead Assembly, over the Snap Plate and Platen Roller and then over the Upper Ribbon Roller. Wind the Ribbon Leader around the Ribbon Take-up Spindle. Rotate the spindle to remove any slack. Close the printhead. Press pause. Close the Media Door.

 

Leave a Reply